Unlike other companies, we not only care about your gift giving experience, we care about the recepient receiving the most beautiful, best sounding engraved whistle possible.  You get the perfect engraved whistle, the perfect size and weighted cork ball installed by us, the perfect finish, buffed and polished by us, the lanyard, and gift box with foam insert. Making it the most exciting gift giving engraved whistle on the market...

Warning: No One Wants To Give An Engraved Whistle That Sounds Horrible...

If you are thinking about buying an Engraved Whistle in the near future, read this immediately...

You do not want to give an engraved whistle as a gift that has a white ball made of stone in it. Unfortunately, since all engraved whistles are larger in size, they all come with a white ball made of stone. The ball is too heavy to blow. It's like trying to to blow a whistle without any ball inside it. One of our customers said it best "It will sound like a dud"...

Make No Mistake About It, You Want To Give The PW3...

The PW3 is the only engraved whistle that uses a large lightweight cork composite ball, that makes the PW3 the best sounding engraved whistle on the market...

Warning: No One Wants To Give An Engraved Whistle That has Imperfections And Scratches...

Unlike the cheap plated whistles found at the big box stores, engraved whistles are polished stainless steel. Unfortunately, the engraved whistle manufacturers are not great at sanding, buffing & polishing. The PW3 is the only engraved whistle that is buffed and polished by us to ensure a blemish free surface to engrave on...

I can’t go into details here, so I created a web page that explains everything in detail. 

Just click on the link: PW3 Details, it takes you directly to the correct page, on my website.

The PW3 Is The Highest Quality Engraved Whistle On The Market, And Here Is Why...

Engraved whistles are different from the cheap non engraved whistles found at the big box stores...

They are bigger in size, and the bigger size presents a problem to engraved whistle manufacturers...

They are setup to mechanically insert a small cork ball inside the whistle after the whistle is soldered together.  The small cork ball doesn't work inside a larger whistle, because it takes all of your breath to barely blow the whistle. Larger whistles require a larger lightweight ball...

They can't mechanically install the larger cork ball.  And they can't put a larger cork ball in the whistle before soldering, because of the heat...

So they install a white ball made of stone before soldering, which is not bothered by the heat.  The problem is the white stone ball is too heavy to blow.  It's like blowing a whistle without any ball inside.  It sounds horrible...

We order our engraved whistles without any ball in them. We tested different size balls.  And the large cork ball give us the best results. So we hand install a large lightweight cork ball after our polishing but before our engraving. That fixes the sound problem with engraved whistles.  No one on the planet does this.

The next problem is the sanding, buffing and polishing.

Sometimes you do get lucky and some of the whistles will come in and will look fine. But a lot of the time they don't.  To give you an example.  We just ordered (at the time of writing this) 1000 of our PW3's.  304 were sent back to the factory to have them sand, buff & polish them over.  Of the 304, over 100 had to be sent back again.  We can't do this on every order.

So we take the factory finish and give it the PW3 finish.  Before we engrave, we sand (if needed) and every PW3 gets buffed and polished using the same buffing wheel and rouge that high end gold jewelry manufacturers use on their platinum jewelry.  Again, no one else on the planet will do this.